Energy performance certificate (EPC)
Certificate contents
Share this certificate
The Old Barley Mow
High Street
Everdon
Daventry
NN11 3BL
2 November 2030
0730-8429-3009-0177-0206
- Property type
- Semi-detached house
- Total floor area
- 143 square metres
Rules on letting this property
You may not be able to let this property
This property has an energy rating of G. It cannot be let, unless an exemption has been registered. You can read guidance for landlords on the regulations and exemptions.
Properties can be let if they have an energy rating from A to E. You could make changes to improve this property’s energy rating.
Breakdown of property’s energy performance
Features in this property
Features get a rating from very good to very poor, based on how energy efficient they are. Ratings are not based on how well features work or their condition.
Assumed ratings are based on the property’s age and type. They are used for features the assessor could not inspect.
Feature | Description | Rating |
---|---|---|
Wall | Sandstone or limestone, as built, no insulation (assumed) | Very poor |
Wall | Cavity wall, as built, no insulation (assumed) | Poor |
Roof | Pitched, 100 mm loft insulation | Average |
Roof | Flat, no insulation (assumed) | Very poor |
Window | Some secondary glazing | Poor |
Main heating | Boiler and radiators, dual fuel (mineral and wood) | Poor |
Main heating control | Room thermostat only | Poor |
Hot water | From main system, no cylinder thermostat | Very poor |
Lighting | Low energy lighting in 45% of fixed outlets | Good |
Floor | Solid, no insulation (assumed) | N/A |
Secondary heating | Room heaters, dual fuel (mineral and wood) | N/A |
Primary energy use
The primary energy use for this property per year is 579 kilowatt hours per square metre (kWh/m2).
About primary energy use
Primary energy use is a measure of the energy required for lighting, heating and hot water in a property. The calculation includes:
- the efficiency of the property’s heating system
- power station efficiency for electricity
- the energy used to produce the fuel and deliver it to the property
Additional information
Additional information about this property:
- Cavity fill is recommended
- Stone walls present, not insulated
How this affects your energy bills
An average household would need to spend £3,785 per year on heating, hot water and lighting in this property. These costs usually make up the majority of your energy bills.
You could save £2,311 per year if you complete the suggested steps for improving this property’s energy rating.
This is based on average costs in 2020 when this EPC was created. People living at the property may use different amounts of energy for heating, hot water and lighting.
Heating this property
Estimated energy needed in this property is:
- 26,815 kWh per year for heating
- 7,487 kWh per year for hot water
Impact on the environment
This property’s environmental impact rating is G. It has the potential to be D.
Properties get a rating from A (best) to G (worst) on how much carbon dioxide (CO2) they produce each year.
Carbon emissions
- An average household produces
- 6 tonnes of CO2
- This property produces
- 18.0 tonnes of CO2
- This property’s potential production
- 6.0 tonnes of CO2
You could improve this property’s CO2 emissions by making the suggested changes. This will help to protect the environment.
These ratings are based on assumptions about average occupancy and energy use. People living at the property may use different amounts of energy.
Changes you could make
Do I need to follow these steps in order?
Yes. Each step builds on the one before it so you can save the most energy.
For example, it’s more energy efficient to insulate your home before you buy a new boiler. A well insulated home will lose less heat so you do not have to run your boiler as often.
Step 1: Increase loft insulation to 270 mm
- Typical installation cost
- £100 - £350
- Typical yearly saving
- £97
Step 2: Flat roof or sloping ceiling insulation
- Typical installation cost
- £850 - £1,500
- Typical yearly saving
- £175
Step 3: Cavity wall insulation
- Typical installation cost
- £500 - £1,500
- Typical yearly saving
- £89
Step 4: Internal or external wall insulation
- Typical installation cost
- £4,000 - £14,000
- Typical yearly saving
- £1,006
Step 5: Floor insulation (solid floor)
- Typical installation cost
- £4,000 - £6,000
- Typical yearly saving
- £208
Step 6: Hot water cylinder insulation
Insulate hot water cylinder with 80 mm jacket
- Typical installation cost
- £15 - £30
- Typical yearly saving
- £230
Step 7: Low energy lighting
- Typical installation cost
- £30
- Typical yearly saving
- £36
Step 8: Heating controls (programmer and TRVs)
- Typical installation cost
- £350 - £450
- Typical yearly saving
- £91
Step 9: Solar water heating
- Typical installation cost
- £4,000 - £6,000
- Typical yearly saving
- £139
Step 10: Double glazed windows
Replace single glazed windows with low-E double glazed windows
- Typical installation cost
- £3,300 - £6,500
- Typical yearly saving
- £240
Step 11: Solar photovoltaic panels, 2.5 kWp
- Typical installation cost
- £3,500 - £5,500
- Typical yearly saving
- £339
Help paying for energy improvements
You might be able to get a grant from the Boiler Upgrade Scheme. This will help you buy a more efficient, low carbon heating system for this property.
More ways to save energy
Who to contact about this certificate
Contacting the assessor
If you’re unhappy about your property’s energy assessment or certificate, you can complain to the assessor who created it.
- Assessor’s name
- Jayesh Mistry
- Telephone
- 01604 647030
- propertyepc@gmail.com
Contacting the accreditation scheme
If you’re still unhappy after contacting the assessor, you should contact the assessor’s accreditation scheme.
- Accreditation scheme
- Elmhurst Energy Systems Ltd
- Assessor’s ID
- EES/008334
- Telephone
- 01455 883 250
About this assessment
- Assessor’s declaration
- No related party
- Date of assessment
- 3 November 2020
- Date of certificate
- 3 November 2020
- Type of assessment
-
Show information about the RdSAP
RdSAP (Reduced data Standard Assessment Procedure) is a method used to assess and compare the energy and environmental performance of properties in the UK. It uses a site visit and survey of the property to calculate energy performance.
This type of assessment can be carried out on properties built before 1 April 2008 in England and Wales, and 30 September 2008 in Northern Ireland. It can also be used for newer properties, as long as they have a previous SAP assessment, which uses detailed information about the property’s construction to calculate energy performance.
Other certificates for this property
If you are aware of previous certificates for this property and they are not listed here, please contact us at dluhc.digital-services@levellingup.gov.uk or call our helpdesk on 020 3829 0748 (Monday to Friday, 9am to 5pm).
There are no related certificates for this property.